This page describes how to operate xTool P3 with xTool software.

Download and install xTool software

(1) Download the xTool software applicable to the operating system that runs on your PC from https://www.xtool.com/pages/software.

(2) Double-click the software you've downloaded to install it.

Connect xTool P3 to the software

(1) Make sure you have finished the preparation of the device first, visit the page: Preparations.

Then use the USB cable to connect xTool P3 to your computer. And turn on the device.

(2) Open the software on your computer. In the top-right corner of it, click the + New project button.

(3) On the right side of the software, click + Select device.

Click + Add Device. Select the device to connect.

In the upper right corner of the software, xTool P3 is connected successfully.

Set up xTool P3 in the software

To know more setup information about xTool P3, go to Set up xTool P3 in xTool Software.

Process materials with multiple processing modes

• To process flat materials, go to Process on Flat Surface with xTool P3.
• To process curved materials, go to Process Curved Materials with xTool P3.
• To process materials in batches,
• • Same design: Process Materials in Batches with xTool P3 (Same Design)
  • Different design: Process Materials in Batches with xTool P3 (Different Designs)
• To process cylindrical and irregular materials, go to Use Rotary Attachment 3 (RA3) with xTool P3.
• To process materials by using the conveyor feeder, go to Use Automatic Conveyor Feeder with xTool P3.