This page describes how to operate xTool X1 with xTool software.

Download and install xTool software

(1) Download the xTool software applicable to the operating system that runs on your PC from https://www.xtool.com/pages/software.

(2) Double-click the software you've downloaded to install it.

Connect xTool X1 to the software

(1) Make sure you have finished the preparation of the device first, visit the page.

Then use the USB cable to connect xTool X1 to your computer. And turn on the device.

(2) Open the software on your computer. In the top-right corner of it, click the + New project button.

(3) On the right side of the software, click + Select device.

Click + Add Device. Select the device to connect.

In the upper right corner of the software, xTool X1 is connected successfully.

Calibrate xTool X1 with the software

To know more calibration information about xTool X1, go to Initial Calibration Tutorial for xTool X1.

Set up xTool X1 in the software

To know more setup information about xTool X1, go to Set up xTool X1 in xTool Software.

Process materials with multiple processing modes

• To process flat materials, go to Process on Flat Surface with xTool X1.
• To process curved materials, go to Process Curved Materials with xTool X1.
• To process materials in batches,
• • Same design: Process Materials in Batches with xTool X1 (Same Design)
  • Different design: Process Materials in Batches with xTool X1 (Different Designs)
  • Engraving inside glass: Engrave Inside Glass in Batches with xTool X1
• To process cylindrical and irregular materials, go to Use Rotary Attachment 3 (RA3) with xTool X1 (Roller Mode) or Use Rotary Attachment 3 (RA3) with xTool X1 (Jaw Chuck Mode) .
• To process materials with the screen printer, go to Use xTool X1 to Engrave a Screen.
• To laser emboss a material, go to Start Laser Embossing with xTool X1.
• To engrave inside glass, go to Engrave Inside Glass with xTool X1.