This article uses a 55W laser module as an example to show the steps of using xTool X1 with software to process a screen for xTool Screen Printer.
For details about xTool Screen Printer tutorials, visit xTool Screen Printer User Guide.
Note: The actual interface may vary. Refer to the interface displayed in the xTool software.
1. Connect xTool X1 to the software
Go to Operate xTool X1 with xTool Software and follow the steps. Make sure the device is connected successfully.
2. Preparations before processing
(1) Install the frame fixing pin.
(2) Insert the frame with screen attached.
Note: Before inserting the frame, ensure that you've mounted the screen on the frame, and that the frame is facing the correct direction.
(3) Close the lid.
3. Select a processing mode and material
(1) On the right panel, select Process on flat surface as the processing mode.
(2) Under Mode, select the material and click Apply.
4. Refresh the background and measure the distance
(1) Click the Refresh background icon to get the background.
(2) Click the distance measurement icon and select the distance measurement point.
5. Design a processing object
(1) You can import or design a processing object from the left bar.
(2) Place the object onto the material according to the real-time captured image.
(3) Click the object and adjust it with tools on the top panel.
(4) Reflect the pattern horizontally or vertically.
xTool X1 will engrave on the back of the screen, so you need to reflect the pattern horizontally or vertically.
Note: You may need to rotate the pattern depending on how you will place the material to be printed.
6. Set parameters
Set parameters for the object in the right panel, including processing methods, module to be used, power, speed and more.
7. Start processing
(1) In the bottom right corner of the software, click Framing and press the start/stop button on xTool X1 to preview the processing area on the material.
(2) In the bottom right corner, click Process to start processing.
(3) In the Check before processing page, follow the precautions and instructions on the right panel. If everything is ready, click Start.
(4) Press the button on xTool X1 to start processing.
(5) Wait until the processing is completed.
