Welcome to xTool Community Support
xTool S1
How to keep XTool S1 from disconnecting?
rubenlogamer
Published on Feb 1,2025
6
790

Hello, I connect my S1 via Wi-Fi because my computer is in the other room, on the other side of the wall.

However, it sometimes disconnects very quickly.

I connect it, start setting parameters for my project, and within five minutes or less, it disconnects. Other times, it stays connected, but once the project is done and I want to start another laser job, it’s disconnected again.

It's very annoying to constantly go from one room to the other because of this.

Is there a way to prevent this from happening? Or a way to make it reconnect automatically after disconnecting?

Thank you.

Preview
Connection
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1 (888) 528-2293
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.