After several weeks of testing and learning the parameters of each material we have started mass production with the conveyor belt and everything is fine, the problem was today that suddenly the final result of the engraving (its size) on the wooden object did not It is the same as the image on the xcs.

The size of the piece is about 6cm and 5mm thick, it's not small..

we have checked the height and it is correct, 

the calibration of the points is correct, 

and both the lens and the camera are clean, 

why is there this difference in proportion and deviation? They are a few millimeters but enough to damage the piece.

I have tried to do the engraving without the tape, that is, in the flat processing mode and the same thing keeps happening to me, in the xcs the drawing is centered on the piece but the final result is skewed to one side... I can't find how to solve The problem, has anyone had this happen?