I have a P2 with all the options including the riser base and conveyor. However, I need to engrave a piece of acrylic that is 20mm thick with an engraving area of 22" x 3.5" which is well within the processing area.

It's too thick to use the conveyor and the overall size of the piece is 27 ¾" x 12 ½" is just too large to go on the slats.

What if I remove the riser base and lift the P2 by inserting four 20mm+ pieces under the four feet.

That way I can insert the part under the P2 and use the regular engraving process.

Is this possible?