Hello,

I was embossing my brass coin and noticed dot is small aka like 1% power ? 

This happened 2 hours into embossing when i noticed, the more time it was paused the more power was regained but max was still around 20-30% i restarted machine and it went fine cant tell 80-100% but after some time it happened again, now i restarted job and it was at 10% power since begginig pausing brought it back some power but its loosing it in 2-3seconds. Anyone any tips something i should do? 

Im on leastest firmware bought it like a week ago and rn i just want to return it im very flustrated its 4000 euro stuff…

yes, ticket is created just hoping someone knows something…