my xtool S1 has been working fine.  I cancelled a project because I was processing something that I did not need.  The next time I went to use my S1, I loaded in the project, changed a few parameters and framed it, no problem, then tried to process it.  It processed fine, but when I went to start, it took forever and an error code came up  “M53 T0” saying “The flash storage encounters an exception or is damaged” I went to how to resolve it and they had me take off the back panel and remove and replace my SD card. I did this, but it still won't start. I still get the same code.  I have only had my machine 3 weeks,  and it is in an area where it isn't bumped or anything. Do I need a new SD card, and should it have gone bad so quickly?