Hi Everyone - I'm new to the xTool Community - I have an M1.  I've been trying to ENGRAVE something on a small wooden train whistle.  I found out that I had to change my setting to Open Plane - that helped, and it worked with a flat, small cutting board when I tested it.  But, I tried again with the train whistle - It auto-measured correctly, I had it on POWER: 85 SPEED 80, and the laser missing the whistle by about an inch - but on the preview, the design was correct.  

One thing I noticed was that in the preview, I cannot see the entire honeycomb-like the outer edges - is that normal?  Any help AT ALL would be greatly appreciated!!  Thank you!!

Dana