Hello,

I got my S1 yesterday, installed XCS and it worked fine with USB connection for about an hour. Then I configured Wifi, but still used the USB connection. It worked. Suddenly “SD Card failure” raised. I found the card in the back, and it wasn't mountable in my macbook either. So I switched to a new one and framing was possible again. But when I try to cut / engrave, I press the blinking button and after a short movement it flashed yellow and the task stops.

So I switched to Lightburn and everything works well.

I took a look at the SD Card and the gcode file and logs have been written.

That's written in XCS log:

[2023-11-15 20:47:48.504] [error] (xcs-www) [ { userInfo: {}, msg: 'Error: ut is empty.' } ]
[2023-11-15 20:47:48.899] [info]  (main)    [ '=> main window loaded.', 7379.408153999597 ]
[2023-11-15 20:47:48.904] [error] (xcs-www) [
 {
   message: "Cannot read properties of null (reading 'id')",
   stack: "TypeError: Cannot read properties of null (reading 'id')\n" +
     '    at M.tryAutoConnectDevice (http://127.0.0.1:3003/renderer/dist/assets/index-4d5de882.js:71:26230)\n' +
     '    at Array.<anonymous> (http://127.0.0.1:3003/renderer/dist/chunk/xcs-vue-family-ea982db5.js:9:2403)\n' +
     '    at M.dispatch (http://127.0.0.1:3003/renderer/dist/chunk/xcs-vue-family-ea982db5.js:9:9893)\n' +
     '    at M.dispatch (http://127.0.0.1:3003/renderer/dist/chunk/xcs-vue-family-ea982db5.js:9:8868)\n' +
     '    at LF (http://127.0.0.1:3003/renderer/dist/assets/index-4d5de882.js:71:96696)'
 }
]
 

Does anyone know how I can make XCS work again? Reinstallation did not help so far.

Isn't it possible to use Lightburn and XCS with the S1?

Kind regards

Marcus