I upgraded xtool d1 pro with extension kit (40w) XCS is not recognizing the new larger working area.

When I added the 40w head I had to bring it in XCS first, do the updates , and then after it was good there , I had to delete are re add the device in lightburn to get it all to work

What do I need to to get XCS to see the new bigger area?

What do I need to do to get it set up in lightburn, just delete and read again?

Update: I changed XCS per the first answer below and the extension area is now showing in XCS. (Thanks Comp56!)

I updated the working area in Lightburn per this post:

https://support.xtool.com/hc/en-us/articles/7881720780183-Set-the-Working-Size-for-Extension-Kit-in-LightBurn

but when I try to move to 430, 930 it hits the limitswitches around 430, 910, I'm assuming this is because of the 40w laser,

Also when I hit home, it goes halfway home, and I have to hit home again to get it to goto the actual home. as is listed in a comment on the thread linked above. I'm going to delete and read the xtool d1 pro in lightburn and see it that helps.

Update 2: deleted and re imported per this link

https://support.xtool.com/hc/en-us/articles/7317000221591-Use-LightBurn-to-Operate-xTool-D1-Pro

in light burn, and it reverted to the old working area, Is there a xTool-D1ProV3.lbdev for the extension kit and the 40w laser?

Do I just manually reduce the working area till it stops hitting the limit switch?

Those values have to be somewhere? what are they?

I'm surprised I can't find it on this community, but the search tool in the site is meh, and google isn't pulling it up.

If not how do I get lightburn to use the limit switches to figure out the actual working area?

How do I fix the hit home twice issue?

Update 3: Via brute force I figured out that my actual working area is 431x907, those numbers seem unround, but that's 1mm before I hit the limit switches.

When I hit home in lightburn, it's still going to x=0, y = about half way, instead of home, then I have to hit home again to get to the actual home.

If I goto 431,907 after the first home, its hitting limit switches so it thinks my working area is smaller than it actually is in the settings somewhere.

I suspect I need a new xTool-D1ProV3.lbdev for the 40w laser and the extension kit?

If not how do I fix the home issue?

Update 4: I opened up xTool-D1ProV3.lbdev in Notepad++ and manually changed the height from 400 to 907, removed the device from Lightburn and re-imported per the instructions in link above, but no joy, I still get the double home problem.

Thanks,

E-