Article·5 min
The Blue and Red Dots of F1/F1 Lite Aren’t Overlapped
What You See
When you use F1/F1 Lite, the blue and red laser should fall on the same spot. The overlapping of the two lasers creates a purple-like dot. However, sometimes you may find them separated. This guide will tell you how to align these dots.
How to Fix It
We can adjust the ball head at the bottom of the laser module. To do so, we'll need to go through two steps: auto-focus initialization and ball head adjustment.
#1 Initialize Auto-Focus
- Connect F1/F1 Lite to a computer and launch XCS.
- On the right panel, find "Use autofocus before init".
- Click on the word "Init" in green. Wait for the device to complete the initialization.
#2 Adjust the Ball Head
- Next to the laser outlet, you'll see a ball head and two screws near it.
- Loosen the screws a bit to make the ball head movable.
- Get a screwdriver and stick it into the bigger hole on the head.
- Adjust the ball head until the two laser dots overlap.
Contact Us
We hope this guide is helpful. And we'd love to hear what you think.
If you have any questions, please contact us at: support@xtool.com
Preview
Was this lesson helpful?
Lesson 7 / 9
Next Lesson
The Cut by xTool F1/F1 Lite Looks Angled at the Image's Edges
5 min
