Welcome to xTool Community Support
xTool M1
Camera calibration.
Paul
Published on Dec 31,2022
1
219

Is there a way to do a camera calibration? No matter where I place my material to be engraved, the result always seems to be too far right and down from where I wanted. I know I can use framing to improve my alignment, but I’m a little disappointed in the alignment quality with the camera. If there is a way I can manually fix this it would be great. Misalignment is consistent on all areas of the bed.

Preview
Camera
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1(800)988 7571
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.