Welcome to xTool Community Support
xTool M1
M1 air assist tube problem -
davide.beni
Published on Nov 21,2024
6
545

Hi,

I have an xTool M1 with air assist from some weeks. Air assist is mounted correctly as described in the manual but I have a problem with a tube. The tube is very rigid and I can't complete my works because when the laser move towards the back, always the tube remain between the laser body and the axis support so the movement was blocked. I tried with my hand to change the tube curve and to make the tube less rigid, but the problem remain the same. I lose a lot of wood panel and It is impossible to work with this situation. I put a photo to understand better the problem. How can I do to avoid it? Is there a new air assist cable perhaps less rigid? I'm not happy with my M1.

Preview
Attach Files
  • air_assist_tube.jpg
  • air_assist_tube2.jpg
  • Hardware
    Maintenance
    xTool Logo

    Contact Us

    Submit a Ticket
    🇺🇸+1 (888) 528-2293
    Service Live Chat

    Copyright © 2025 xTool All Rights Reserved.