Welcome to xTool Community Support
xTool F1 Ultra
Creative Space and Depth Mapped engraving
PhilW
Published on Oct 29,2024
1
73

I have a question about Depth Mapped engraving and the F1 Ultra/Creative Space.

I have a project that is made up of multiple parts (a brass coin design) - I was having issues with the order as part of the design is a Vector Engrave and part is a Deep Emboss.  Basically if the Emboss runs first, then the vector engrave seems to start at the ending focus depth of the emboss rather than going back to the original focus depth. 
I learned how to work with that by manually ordering the parts in the layer list, and that works well.   But it seems if I try to batch up multiples of my project, the second emboss again starts at the lower focus level.  The vector engraves seem to run together, but the embosses appear to run sequentially.   
Is there a way to set a “undo the step down operations” after an engrave or a way to set “start at this height” at a part level?
Or there could just be something I'm not considering - any ideas are appreciated.  

Preview
Engraving/Cutting Quality
Laser Focus
Copyright © 2024 xTool All Rights Reserved.
Call Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales Hotline
+1(970)638-7030
Customer Service Hotline
+1(775)587-7760
Email Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales and shipping related
vicky@info.xtool.com
vicky@xtool.com
After-sales and shipping related
support@info.xtool.com
support@xtool.com
Technical Support
support@info.xtool.com(US)
support@xtool.com(US)
support.eu@xtool.com(EU)
support.uk@xtool.com(UK)
Brand Cooperation
If you want to cooperate with
xTool on causes like education,
public welfare, innovation, etc.,
or if you want to review our
machines, please email
partner@xtool.com
US headquarter
XTL US INC. 16035 Arrow Hwy.
Irwindale. CA91706
Copyright © 2024 xTool All Rights Reserved.