Account Center

Hi gang, newbie here. I just kicked off my first cutting balsawood project. I was stoked, it is this bee model that looked like a fun first shot.

I loaded the model, got it lined up with the materials, set the frame, started the job… About an hour and ten minutes into the job, it just bailed on the jpiece it was cutting and then restarted the whole it from another point. I wasn't watching close enough at that point to observe that it had restarted and it ran for about thirty minutes or more like that.

It ended up cutting through already cut pieces and also cut off of the material and the frame I had set, which is scary af for me to witness. I was under the impression that it would ONLY cut in the framed area.

This happened twice - after the first failed, I created a new job with just the pieces that I needed and the SAME THING HAPPENED. It seemingly randomly aborted the job midway through a shape and then restarted, cutting through other pieces.