Account Center

Has anyone had this issue? I originally thought it was a software issue in Lightburn, but just did a test in XCS and got the exact same result, which leads me to believe it's a hardware issue and not a software issue. When I'm scoring/engraving on a set size material such as a slate coaster or cutting board the artwork is consistently 2mm to the right. This happens in both Lightburn and XCS. I use both absolute and relative/user origin. This does NOT do this if I'm cutting out the art as well.  Everything was working fine; I use a jig as a tool layer in Lightburn and everything was dead center. Now it's doing this. All software is up to date as well as firmware. I'm at a loss. Any ideas?