Account Center

Does anyone have any problems with their framing after the new software update?

I have had problems in XCS 2.0 when I switch tabs and the framing keeps the older design in the "buffer". I have had to close out that tab/project for it to finally frame the item I want. This does not happen often but enough for my irritation.

I also have framing issues when I move an object within the canvas and the framing does not update to represent the new location. the framing does not live update if I move an object while the framing is active nor does it move if I turn the framing off and then back on. I have actually burned in the wrong place because of this. This is the bane of my engraving right now.

I did not have this issue when using XCS 1.0. On the contrary, the framing would actually provide live updates when moving things on the canvas with framing active. I liked this feature weather or not it was supposed to exist.

My software is the current XCS 2.0 and my firmware is up to date.

Does anyone have any fixes they have done or any work arounds I could try?