Welcome to xTool Community Support
xTool D Series
Brand new D1 Pro triggers over the limit errors at random
scottcall
Published on Dec 31,2023
7
3119

Just assembled the D1 Pro (5W Red and gold if it matters) and I was impressed with both the ease and quality.

 

However, I'm getting a weird issue where the over limit alarm goes off even when the laser unit is nowhere near the edge and and even when it's moving on the Y axis (so the laser isn't even moving on the crossbar)

 

I've double checked the main board connector, the sensor connectors on the cross bar, etc.

 

Any other clues on where to look?

Thanks!

Preview
Hardware
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1 (888) 528-2293
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.