Welcome to xTool Community Support
xTool M1
engraving on wine glass
aagorden
Published on Dec 28,2023
1
737

Good evening, I have a question. I have the RA2 rotary Pro. I use the honeycomb base riser instead of the wood blocks that came with my xtool M1. (so far I'm loving the machine). I have an issue with engraving glass. I'm having an issue as when the framing began, the rotary rotated all the way around. I got two lines after framing. I expected for the laser to only frame where I had the small image and it did not. When the process began , I got these scary lines. I'm using black chalk mineral paint. The glass was completely dry. I got the message to 'Ensure that the red spot is at the highest point of the cylinder'. I leveled the glass. I used the distance measured (auto measure) at 0.8mm, I entered the perimeter of my glass to 11 inches. I don't know what that would be in mm and Diameter did an auto set at 3.5mm. The mode is set to 'Chuck'. Set to "Laser Cylindrical', Material is 'User Defined'. I'm worried that I'm doing something terribly wrong.

Preview
Attach Files
  • Image of lines engraved on glass.jpg
  • Rotary Attachment
    xTool Logo

    Contact Us

    Submit a Ticket
    🇺🇸+1 (888) 528-2293
    Service Live Chat

    Copyright © 2025 xTool All Rights Reserved.