Account Center

On the page “FAQs on xTool F2 Ultra UV” ,  I am informed that this laser is good for Cutting: Wood, acrylic, plastic, leather, fabric, paper, glass, and more.

However when I set my material to 1/8"(3mm) Silver Mirror Acrylic , while I get some default settings for Engrave, there is nothing for Cut.

I asked Support “what are the recommended settings for cutting acrylic with f2 ultra UV”

The response was : 

Recommended Settings for Cutting Acrylic with xTool F2 Ultra UV

For cutting acrylic on the xTool F2 Ultra UV, the following laboratory-tested reference data is available:

• Maximum Thickness: Up to 12 mm acrylic can be cut.

Source: FAQs on xTool F2 Ultra UV 

Has anyone actually cut acrylic shapes with this machine?

If so, what settings should I use?