Just started messing with my new F1 Ultra. As I was trying to find a good set up for a tumbler engraving project, I see these stripe shaped markings on the bare metal. I am guessing these are the laser lines. How can I get a smoother finish?
Here is what I did:
First Run with Blue: %40 Power, Speed 400, Pass 1, Lines per cm: 300, Bi-Directional
Second Run with IR: %25 Power, Speed 400, Pass 1, Lines per cm: 300, Bi-Directional, 30kHz
Copyright © 2025 xTool All Rights Reserved.