At 0cm to 1.5 cm the laser is above the horizontal bar at the left of the workspace, not above the slats, meaning that when i cut material there, I will also engrave the machine. At 60cm I’m still quite further than 1.5cm from the horizontal bar on the right end. But I can’t further laser than 60cm because the software does not allow that. So I basically only have 58.5 of workspace. This becomes even more apparent when using the conveyor belt because then a plate can never get above the bar on the left. I’m super annoyed by that because that means any artwork of 60cm wide which is a standard size, becomes impossible to handle now. Can this be solved? With a software patch or by changing something in the hardware?