Welcome to xTool Community Support
xTool F1 Ultra
Bug Report - Engraves belt when repeating batch job.
aurbanowski
Published on Jul 3,2025
2
51

Hi All, 

      I just noted a bug in the software, and didn't know who at XTool to bring it to, so I figured I would post it here in hopes that someone sees it at passes it on to the right people…  I have an F1 Ultra, and was performing some batch processing with different designs, (a feature which is SWEEEEEEET by the way).  When I ran out of blank material, the conveyor correctly advanced a few times, and then stopped, having detected no new product.

     Once I was able to get more blanks, and put them on the conveyor, I double-tapped the green start button on the machine to re-initiate the job.  Rather than advance the conveyor, or use the camera to check for more blank material, it immediately started engraving directly onto the belt.

     I am guessing (but I did not test), that it was re-engraving the last set of pieces that it had finished earlier, which is perfect for all modes EXCEPT the two batch modes that use the conveyor.  I am thinking that when in one of these modes, the command to advance the conveyor should, at the very least clear the data from the last cut so that it does not attempt a re-cut once the product has been moved.

 

Anyway, just wanted to report the issue in hopes that it will be corrected in a future software release, but if not, just be aware of the behavior, and your belt will not be attacked as mine was.  

 

Happy Engraving!

Andy

Preview
General
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1 (888) 528-2293
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.