The Blade Won't Cut Through The Material
Updated Jul 12,2024
Updated Jul 12,2024

Issue Description

The blade won't cut through the material. A few lines are not cut through. The cutting edge may be warped.
Possible Causes:
 

#1 Wrong material Setting in XCS

  1. Processing parameters vary from the material.
  2. Choose the corresponding material in XCS.
  3. Proceed with the default processing parameters.

Note: Different materials have different processing parameters.

 

#2 Improper Processing Parameters

This issue may be solved in the following ways:
  1. Reduce the processing speed.
  2. Increase the cut pressure.
  3. Add processing pass.
 

#3 The Blade Is Worn Out

The harder the material is, the easier the blade gets worn out.
If yes, replace it with a new one.

Note: The blade may be worn out due to high-hardness materials cutting, and therefore affect the cutting performance. For example, the material won't be cut through, and the cutting edge may be warped.

 

#4 Check Calibration

  1. Click the gear icon on the top right corner.
  2. Go to 'Setting'.
  3. Click 'Calibrate' as shown in the photo below.

Note: Replacing or hitting the blade will make it slightly move, which will affect processing accuracy.

 

#5 Deformed Baseplate or Material

  1. Make sure the surface of the material or the baseplate is even. Replace them if necessary.
  2. If the baseplate is slightly deformed, use the blade calibration to improve the cutting result.
  3. If the base plate is significantly deformed and beyond repair, please contact xTool customer support or your dealer.
Preview
Was this page helpful?
1 out of 2 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Copyright © 2024 xTool All Rights Reserved.
Call Us
Telephone
Pre-sales : +1(970)638-7030
After-sales : +1(775)587-7760
Email
Pre-sales : vicky@info.xtool.com
After-sales : support@info.xtool.com
Service Time
Mon-Fri : 7:00 am - 5:30 pm (PT)
Sat-Sun : 8:30 am - 5:30 pm (PT)
Copyright © 2024 xTool All Rights Reserved.