Connect the Device Through an IP Address
Updated Sep 21,2023
Updated Sep 21,2023

This applies to:

D1 and D1 Pro with all laser modules.

 

To set up an IP connection, you must complete the Wi-Fi connection first. Please refer to the link below to connect your machine through Wi-Fi.

Then, move on to the following instructions to set up the IP connection.

  1.  Make sure your machine and computer are on the same network.
  2.  Go to Connect device page like before but this time see the IP section.
  3.  Enter the machine's IP address and click on the Connect button.
  4.  After it's done, you'll see the same info under the Wi-Fi Setting with a visible IP address like you do with the Wi-Fi connection.

Note: Your router may update the IP address from time to time, make sure you get the right IP address before you enter it under the IP section.

Preview
Was this page helpful?
14 out of 22 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1 (888) 528-2293
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.