Connect the Device Through Wi-Fi
Updated Dec 11,2023
Updated Dec 11,2023

This applies to:

D1 and D1 Pro with all laser modules.

 

There are three ways to connect your machine to your computer: USB, Wi-Fi, and IP. The first one requires a USB cable while the other two are wireless. If you'd like to connect via Wi-Fi or an IP address, please follow the below instructions.

 

#1 Connect via USB First

Before you can connect via Wi-Fi or IP, you need to connect via USB so the settings can be saved to the machine. Please follow the steps:

  1. Connect your machine to the computer with a USB cable.
  2.  Launch XCS, click on Connect Device, and go to the device setting (the wheel sign).
  3.  Your machine should appear under the USB section. Select it and connect.
  4.  In case you can't find your machine on the list, please refer to this link to troubleshoot:
    XCS Can't Find Device Through USB

 

#2 Configure the Wi-Fi

  1.  Go back to the device setting and find the Wi-Fi setting under the Basic info page.
     

  1. Enter your Wi-Fi name and password. Make sure your machine and the computer are on the same network.
     

It's recommended that your Wi-Fi name and password contain no special characters (e.g. !@#$, etc), otherwise it may not connect.

  1.  If it's connected successfully, you will see the below message.

 

#3 Switch to Wi-Fi Mode

  1. On the device setting, click on the Switch device button.
     
  1.  You'll find your machine and its IP address under the Wi-Fi section.
     
  1.  Now you can select your machine to connect via Wi-Fi. And you can see the connection mode is Wi-Fi.
     

  1.  After it's done, check if it's connected under the Wi-Fi Setting with a visible IP address.
     

 

Preview
Was this page helpful?
170 out of 210 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Copyright © 2024 xTool All Rights Reserved.
Call Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales Hotline
+1(970)638-7030
Customer Service Hotline
+1(775)587-7760
Email Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales and shipping related
vicky@info.xtool.com
vicky@xtool.com
After-sales and shipping related
support@info.xtool.com
support@xtool.com
Technical Support
support@info.xtool.com(US)
support@xtool.com(US)
support.eu@xtool.com(EU)
support.uk@xtool.com(UK)
Brand Cooperation
If you want to cooperate with
xTool on causes like education,
public welfare, innovation, etc.,
or if you want to review our
machines, please email
partner@xtool.com
US headquarter
XTL US INC. 16035 Arrow Hwy.
Irwindale. CA91706
Copyright © 2024 xTool All Rights Reserved.