This article describes how to make stickers and labels with xTool C1 Color Cutter (hereinafter referred to as the xTool C1).
Preparations
🔔 You can purchase the processing tools, pens, and materials you need at xtool.com.
- xTool C1
- xTool C1 cutting mat or electrostatic mat
- xTool C1 fine-point blade
- xTool C1 ink cartridge
- Material to be processed (DURA printable glossy sticker paper and printable transparent sticker paper are recommended.)
Procedure
1. Connect xTool C1 and the software
Refer to "Connect xTool C1 to the software" complete the connection.
2. Load the material
Attach the material to the cutting mat or electrostatic mat, then load the cutting mat into xTool C1.
3. Design processing objects
(1) Click Mode and select Stickers & Labels.
(2) Use the tools in the left pane to design objects.
🔔 Note: You can import images, insert shapes, enter text, AI-generated designs, and so on.
4. Set processing parameters
(1) Select the objects, set Process Type as Print and Cut, set the related processing parameters, and click Make.
🔔 - Kiss Cut: Cuts only the sticker layer, leaving the release paper intact. The stickers remain on the release paper for easy storage and peeling. Kiss Cut is recommended for making stickers.
- Die Cut: Cuts all the way through the material, separating both the sticker and the release paper. When making die-cut stickers, enable “Easy-Peel Edge” to make it easier to cut out and peel off the stickers.
(2) Click Material, select the material type, then click Apply.
🔔 If you are using xTool official materials, the material can be identified automatically. Click Apply in the pop-up window.
5. Install processing tools and complete the processing
(1) Follow the prompts in the Pre-processing Check section to install the required processing tools. After the processing tool status shows as normal, click Start.
(2) When the interface indicates that processing is ready, press the multifunction button on xTool C1 and wait for the tasks to finish.
(3) After all the tasks are finished, click Finished and press the multifunction button on xTool C1 to eject the cutting mat. Then, remove your works.
