Introduction to the Inner Engraving Processing Area for xTool X1
Updated Oct 29,2026
Updated Oct 29,2026
The processing area depends on the material size and the design element positions. After securing the positioning piece, enter the material's length, width, and height to determine the coordinates of its centerline.
Maximum material dimensions:
- Length: 300 mm
- Width: 300 mm
- Height: 150 mm
The processable area is determined as follows:
- If the material height is 50 mm or less, the entire processing area is available.
- If the material height exceeds 50 mm, only the area within 60 mm of the workpiece’s right edge can be processed.
Material height | Width restriction | Length restriction |
Material height ≤ 50 mm | / | / |
50 mm < material height ≤ 100 mm | Only the area within 60 mm of the workpiece’s right edge can be processed. | / |
Related Link
Preview
Was this page helpful?
2 out of 2 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket 
