This article introduces the vibration suppression calibration process for xTool X1. Before calibration, ensure that you've connected xTool X1 with xTool software.

Step 1: Open the calibration page

(1) In the upper-right corner, click the device settings icon.

(2) In the Device settings dialog box, click Calibration.

(3) Click Start next to Vibration Suppression Calibration.

Step 2: Watch the introduction video

Step 3: Ensure that all laser modules are installed

Install all laser modules and click All installed.

Step 4: Confirm the laser modules you've installed

Check the laser modules you've installed. If the laser modules shown in the software is the same as those you've installed in xTool X1, then click Confirm.

Step 5: Clear the baseplate

Clear the baseplate of xTool X1 and click Cleared.

Step 6: Close the lid

(1) Close the lid of xTool X1 and click Closed.

(2) Click Next.

Step 7: Wait for the automatic calibration to complete

(1) Wait for the calibration to complete.

(2) Click Next to finish the whole process.