Download PDF file (multi-language)
Safety first (important)
- This product can only be used with xTool X1 automatic conveyor feeder. Before use, ensure that the automatic conveyor feeder has been installed in xTool X1.
- Before use, ensure that you have read and been familiar with the contents of the Safety Instructions of xTool X1 automatic conveyor feeder.
- Ensure that the placement direction of the conveyor rail is parallel to the feed direction during processing.
List of items
|
|
|
|
Conveyor rail | Support beam | Support leg | Support leg base |
|
|
| |
Screw M3*6 | Screwdriver | User manual |
Install the conveyor rail
🔔 Assembly requirements for the conveyor rails vary depending on the width of the material to be processed. Please assemble the conveyor rails based on the actual conditions.
Scenario 1: Width (W) of the material to be processed: 152 mm ＜ W ≤ 457 mm
1. Assemble conveyor rails and support legs
2. Install the support leg bases
Insert the support leg base into the support leg, then rotate the base clockwise to secure it.
3. Install support beams
4. Install the conveyor rails
Place the assembled conveyor rails in front of and behind the conveyor feeder, and adjust the support leg bases to ensure that all conveyor rails are at the same height.
🔔 If the conveyor rails cannot be adjusted to the same height, use the support legs to connect this product and the original conveyor rails. This ensures overall stability and prevent material displacement during processing, which would affect processing results.
Scenario 2: Width (W) of the material to be processed: 457 mm＜ W ≤ 610 mm
1. Assemble conveyor rails and support legs
2. Install the support leg bases
Insert the support leg base into the support leg, then rotate the base clockwise to secure it.
3. Install the conveyor rails
🔔 For materials with a width greater than 457 mm and up to 610 mm, install the conveyor rails:
- With method 1 if the material thickness is 6 mm or less
- With either method if the material thickness is greater than 6 mm
- Method 1: Connect this product and the original conveyor rails using support legs, then install them to xTool X1.
(1) Rotate counterclockwise to loosen the thumb screws, and remove the original conveyor rails.
(2) Use support legs to connect this product and the original conveyor rails.
- Connect the front conveyor rails
- Connect the rear conveyor rails
(3) Install the conveyor rails to xTool X1 and tighten the thumb screws clockwise.
- Method 2: Place the assembled conveyor rails in the middle position of the original conveyor rails.
(1) Assemble the conveyor rails referring to the steps in scenario 1.
(2) Place the conveyor rails.
🔔 Ensure that the lengths of A and B are equal and all conveyor rails are at the same height.
Use the conveyor rails
The procedures for processing using the conveyor rails are the same as those of xTool X1 automatic conveyor feeder. For details, see Use Automatic Conveyor Feeder with xTool X1.
