What metals can xTool MetalFab 1200w cut?

Note: Don't use xTool MetalFab to process high-reflective materials like Au/Ag/Copper, or it will damage the laser machine!

Use xTool air compressor & dryer & SaveGas nozzle (Telescopic nozzle) to cut 4mm stainless steel:

If you use nitrogen or argon cylinders, refer to the chart above. Most steps are similar.

1. Preparation work

• Connect the air compressor & air dryer to the laser welder. Connect the CNC cutter to the laser welder.
• Turn on the xTool air dryer first, and then turn on the air compressor. Set the air pressure at 1.0MPa, and wait for the machine to generate air.
• Install the SaveGas nozzle, turn on the laser welder and CNC cutter.

2. Place and secure the material

3. Connect the machine, insert files

Refresh the background, adjust the position where you wanna cut

4. Add lead-in lines

For thick metals of 3mm and above, to achieve the best cutting results, it's recommended to add lead-in lines.

Click to see when you need add lead-in lines and how>>

5. Choose cutting parameters

For stainless steel of 4mm and above, brass and aluminum of 3mm and above, after adding lead-in lines, the soft-start function will be enabled and the settings will be applied automatically.

6. Calibrate the capacitive sensor

7. Framing

8. Adjust the focus position and processing

• Click process to get the recommended focus position

• Adjust the focus position

For focus position between -10 to +5

Follow the video, rotate the knob, set the scale at the recmmedned value.

For focus position beyond the range from -10 to +5

Use xTool double-layer nozzle & oxygen cylinder cut 5mm carbon steel(ASTM 36) :

1. Preparation work

• Connect the oxygen cylinder to the laser welder. Connect the CNC cutter to the laser welder.
• Turn on the gas, set the oxygen pressure at 0.06-0.07 MPa.
• Install the double-layer nozzle and focus extension tube, turn on the laser welder and CNC cutter.
• Calibrate the welding gun light position.

2. Place and secure the material

3. Connect the machine, insert files

4. Add lead-in lines

For thick metals of 2mm and above, to achieve the best cutting results, it's recommended to add lead-in lines.

Click to see when you need to add lead-in lines and how>>

5. Choose cutting parameters

6. Calibrate the capacitive sensor

7. Framing

8. Adjust the focus position and processing

When using the 20mm focus extension tube, the focus position should be adjusted to -2 for 5mm carbon steel.