Download PDF files (multi-language)

Safety first (important)

Read and get familiar with all safety precautions and procedures before using the product. Strictly follow all safety precautions.

• The product can work only with xTool P3. Read and get familiar with all safety precautions and procedures about xTool P3 before using this product.
• Do not move or place this product on a slope.
• Do not use this product to move xTool P3 on uneven surfaces (such as a rocky road).
• Before using xTool P3 for processing, make sure that the ON positions of the four brake pedals on this product have been stepped on.
• To prevent rust, do not store or use this product in a humid environment.

List of items

Unbox xTool P3 Mobile Work Stand and check the items inside the pack. If you find items missing or broken, please contact us for after-sales support.

Assembly and use

1. Place the columns as illustrated.

2. Place the four beams named beam A.

3. Place the two beams named beam B.

4. Place the two beams named beam C.

5. Secure the beams using screws.

6. Install board brackets.

7. Install the boards.

8. Install the caster wheels.

9. Rotate the stand 180 degrees.

10. Step on the ON positions of the four brake pedals to secure the stand.

11. (Optional) Install a board on the middle or bottom layer of the stand to place processing materials.

■ Install a board on the middle layer of the stand.

Installation method 1:

(1) Install board brackets.

(2) Install the board (recommended dimensions: 590 mm × 1140 mm × 12 mm). The final installation result is shown below.

Installation method 2:

(1) Install board brackets.

(2) Install the board (recommended dimensions: 690 mm × 1040 mm × 12 mm). The final installation result is shown below.

■ Install a board on the bottom layer of the stand.

(1) Install board brackets.

(2) Install the board. The final installation result is shown below.

Recommended board dimensions 1: 590 mm × 1140 mm × 12 mm

Recommended board dimensions 2: 690 mm × 1040 mm × 12 mm

12. Place xTool P3 on the stand.

FAQ

1. Why does the product I received have cosmetic defects such as black spots, pits, or an uneven surface?

All beams are hand-welded, sanded, and powder-coated by workers. Minor scuffs, spots, or small pits are unavoidable at corners and weld seams. However, they will not affect the functionality or stability of the mobile work stand, so you can use it with confidence. Thank you for your understanding.

2. What should I do if the plug-in slots are too tight to fit together?

Due to hand welding, the slot positions may not be perfectly aligned. If they are hard to seat, gently tap them into place using a rubber mallet.