Contents

Video Guide

Issue Description

Solution

#1 Adjust the U-Shaped Bearings

#2 Check the Belt Fastening Piece

#3 Check the X-Axis Motor Cables

#4 Check the Motherboard Cables

The Laser Module of xTool S1 Falls Off the Rails or Won't Move Smoothly

Updated Dec 19,2023

This content applies to:

xTool S1 with all laser modules.

Video Guide

Issue Description

During the operation of the machine, you may hear unusual sound from the X-axis gantry. Or, you may find the laser module difficult to move when the machine is power off.

Solution

#1 Adjust the U-Shaped Bearings

1. Power off the machine. See if the laser module carriage is popped out

2. Check if any of the bearings has fallen off the rails. If so, put the bearings back on the rails.

#2 Check the Belt Fastening Piece

1. Take off the laser module, press down the movable plate.

2. Detach the fastening piece from the carraige.

3. Move the carriage left and right a couple of times. See if it moves smoothly.

4. Move the belt fastening piece in the same way. See if it moves smoothly.

5. Check the fastening piece for any deformation.

#3 Check the X-Axis Motor Cables

1. Power off the machine. Find the motor protective cover at the back of the X-gantry and remove the four screws.

2. Check the cables for any breakage or unusual bent. Unplug and replug the cables.

#4 Check the Motherboard Cables

Check the cables for the ports that are numbered with 6 (X-axis encoder) and 12 (X-axis motor) for any breakage. Check the ports for any unusual bent.

Contact Us

If you have any questions, feel free to contact us at: support@xtool.com

Preview

Was this page helpful?

7 out of 9 found this helpful

Help Ticket

Use this help ticket to submit your issue. We will respond within 1 business day

Submit a Ticket