Video·2 min

Spot a Quality K9 Crystal Blank in 3 Checks

xTool Official


A failed crystal engraving is often caused by the blank, not the machine. Bubbles, streaks or a green tint inside K9 crystal scatter the laser and leave cloudy or broken results, especially with inner engraving. In this quick video, you’ll learn three checks to run before you engrave:

  1. Zoom in: look closely for tiny bubbles.
  2. Hold it up to the light: check for streaks running through the glass.
  3. Set it on white paper: see whether the crystal has a green tint.

A good blank passes all three: no bubbles, no streaks, no tint. Looking for blanks you can trust? Try xTool K9 Crystal Blanks, made for laser engraving.

Tip: Run these checks every time you open a new batch of blanks, before you set up your design.

Preview
Was this lesson helpful?
Lesson 1 / 7
Next Lesson

Start Inner Engraving with xTool F2 Ultra UV

7 min

Master your machine

Expert 1-on-1 Machine Training

REQUEST CONTENT
xTool Logo

Contact Us

🇺🇸+1 (833) 588-4887
Service Live Chat

Copyright © 2026 xTool All Rights Reserved.