Article·5 min

Clean the Cyclone for AP2 Max

xTool Official

Generally, you need to clean the cyclone every 3 to 6 months. You must disconnect the power cable before cleaning the cyclone.

1.Take the cyclone down

1) Disconnect power.

image.png

2) Remove the exhaust pipe.

image.png

3) Remove the NFC baseplate.

image.png

4) Release draw latches on both sides to unlock them.

image.png

5) Take the cyclone down.

image.png

2. Disassemble the cyclone

1) Remove the screws using a 3 mm hex key.

image.png

image.png

2) Take the cyclone components out.

Note: Remove all screws completely before removing the cyclone components. Do NOT force removal. Forcing will break the mounting posts.

image.png

3. Clean the cyclone

1) Pour out accumulated dust and debris.

image.png

2) Spray with degreaser.

image.png

3) Wash with running water.

image.png



4. Install the cyclone back

When the cyclone components are dry, install them back in place.

1) Reinstall the components in the order as illustrated.

image.png

2) Install the screws.

image.png

3) Reinstall the cyclone and lock the draw latches.

image.png


4) Reinstall the NFC baseplate.

image.png




Preview
Was this lesson helpful?
Lesson 2 / 2

Master your machine

Expert 1-on-1 Machine Training

REQUEST CONTENT
xTool Logo

Contact Us

🇺🇸+1 (833) 588-4887
Service Live Chat

Copyright © 2026 xTool All Rights Reserved.