Welcome to xTool Community Support
xTool P2 Series
Laser Dropping in Power
abeidoun24
Published on Feb 2,2025
2
636

Hello, I recently bought an Xtools P2S, and I was working on engraving some logos. However I noticed an issue that at the start of a pass the engraver is fine, but as it reaches the end it is much fainter of an engraving. In my test I did 2 passes so I can confirm that it's due to the end of a pass because when it went to do the second pass it was strong, then as it reached the bottom it was fainter then the rest.


Is this a setting I might have to modify, or is it an issue with the laser, any help would be great.

Thank you,

Preview
Processing
xTool Logo

Contact Us

Submit a Ticket
🇺🇸+1 (888) 528-2293
Service Live Chat

Copyright © 2025 xTool All Rights Reserved.