Welcome to xTool Community Support
xTool P2 Series
Angled/Sloped Engraving
Hello! I'm trying to cut out a UniFi nanoHD AP mount with my xTool P2. The tabs to connect the mount to the AP are sloped/angled, and I'm trying to figure out how to create a sloped engrave in XCS. Any suggestions?
I found this design as an STL, that I am attempting to export as SVG files from TinkerCAD, then build something I can cut in XCS.
If there is a better way, please advise.
Attach Files
UAP Bracket.stl
XCS
Call Us
Service Time
Mon-Fri,9:00-18:30 PDT
Mon-Fri,9:00-18:30 PDT
Pre-sales Hotline
+1(970)638-7030
Customer Service Hotline
+1(775)587-7760
Email Us
Service Time
Mon-Fri,9:00-18:30 PDT
Mon-Fri,9:00-18:30 PDT
Pre-sales and shipping related
vicky@info.xtool.com
vicky@xtool.com
vicky@xtool.com
After-sales and shipping related
support@info.xtool.com
support@xtool.com
support@xtool.com
Technical Support
support@info.xtool.com(US)
support@xtool.com(US)
support.eu@xtool.com(EU)
support.uk@xtool.com(UK)
support@xtool.com(US)
support.eu@xtool.com(EU)
support.uk@xtool.com(UK)
Brand Cooperation
If you want to cooperate with
xTool on causes like education,
public welfare, innovation, etc.,
or if you want to review our
machines, please email
partner@xtool.com
xTool on causes like education,
public welfare, innovation, etc.,
or if you want to review our
machines, please email
partner@xtool.com
US headquarter
XTL US INC. 16035 Arrow Hwy.
Irwindale. CA91706
Irwindale. CA91706
Join xTool Squad
Copyright © 2024 xTool All Rights Reserved.