I am using an XTool S1 2w. It's less than a week old. I have about an hour of time on it. When I process, I am getting (hundreds of) the following message from XCS c2.0.117-beta when I process:

Cleaning the laser module

Oops! The cumulative processing time of the device is too long. The smoke from processing accumulates on the lens, which may lead to a poor performance in laser processing.

Please clean the lens with a dry tissue or cotton swab in a timely manner.

I have cleaned the laser lens, lens protector and the air nozzle as outlined here: https://support.xtool.com/article/1066.

I'm guessing this is from Device Settings → Working Info → Lens Protector cleaning reminder (which I have enabled). This is a handy feature, but the message persists after cleaning. It's incredibly annoying because 1) I have to click out of at least five of these messages (after the timeout) each time I cut and 2) This seems to negate the cleaning reminder because I can't reset it and I can't tell how long it's been since I last cleaned it. 

Anyone know how to appease this message?