Hello Everyone,

I've just done my first tests with my Xtool P2, and I have the impression that after doing several engravings on 3 mm Basswood, at a certain speed and high intensity, the laser doubles (blurred engraving).
And on the other hand, at low speed and low intensity, the laser engraves too lightly.

I followed all the start-up instructions, so I was wondering if I'd forgotten to remove any protectors or covers, I don't think so.
I'm also wondering if there are any other adjustments to be made that I've forgotten.

For the record, I've done the calibration as requested by Xtool and the laser fires right at the centre of the circle.

Can anyone help me please, or what should I conclude from this about the situation I'm facing?

I have attached a photo of the test board.

Thank you very much in advance for your help and kind regards.

Channa.