Hello,

I'm experiencing a couple of issues with my XTool S1 and hope to get some guidance or solutions.

Please see the video I have taken:
https://www.youtube.com/watch?v=Kj7UlHEEdxc

Processing Area Detection Issue: The laser is positioned all the way back, but there seems to be an incorrect detection of the processing area. There's a gap of about 25 mm at the top, which shouldn't be there. This issue is restricting my ability to utilize the full advertised cutting size.

End Stops Not Functioning Properly: The front end stops don't seem to halt the movement of the laser bar. Instead, the laser collides with the LED, bypassing the end stops. This doesn't seem right, and I'm unsure why it's happening.

Any advice or insights into these issues would be greatly appreciated.

Thank you!