Welcome to xTool Community Support
xTool S1
Marking and working area don't match !
Psioui
Published on Jan 7,2024
10
2955

Hi there,Hi there !

 

It seems that the “working area” and the “marking area” don't match

 

I create a rectangle (blue) as big as the S1 should be able to work 498 × 319 mm.

It fits perfectly on top of the “working area”.

 

Then I did a marking of the full travel of the laser, you can have a look at the picture, both are not align on top of each other.

 

From the origin point, the laser is off by -5.9mm on the X axis and 24.6mm on the Y axis from the “working area”

 

I tried to work with a piece of wood of 298.45mm x 298.45mm, I tried to put it in a lot of places in the bed, but at all time I was outside of the “working area”

 

Is there any way to align the “working area” with the actual travel of the beam?

 

I tried to reboot the computer, turn off/on the S1 etc….

Both XCS and S1 are up to date.

 

I thought that in the homing sequence, when the proxy switch is hit, this will reset the position to 0,0 of the head.

 

Have a look at the pic

 

Thanks

Preview
Attach Files
  • image 1.jpg
  • working area
    processing area
    xTool Logo

    Contact Us

    Submit a Ticket
    🇺🇸+1 (888) 528-2293
    Service Live Chat

    Copyright © 2025 xTool All Rights Reserved.