Account Center

I'm using third party software to process photos for laser engraving including dithering.

If I use xTool Studio to bitmap engrave one of these images, there is no way to bypass / turn off the xTool Studio dithering so the image gets “dithered” a second time.

Need a way to bypass / turn off xTool Studio dithering when bitmap engraving.

Can this feature be added to xTool Studio?  I can use Lightburn on my S1 and it has a pass through check box, but I would like to use xTool Studio for my S1's and my new P3.

Also can an xTool Studio, P3, and F2 board be added as a selection for this forum?