Account Center

P2 Laser was not cutting 3 mm plywood in 6 passes with 95/10 (Power/speed)  settings and it was thick cut on wood rather than thin sharp, and it was creating burn ash on side edges.

I read your article and cleaned all lenses without removing anything with soft cotton buds and it got cleaned also, after few runs its beam is focusing on the wall of machine instead of bottom surface.

I checked the beam focus by using optical path setup, it came positive with beam on center area in all places.

I captured the pic to show you where the beam is hitting, Its hitting on the side wall, you will see slight burning on the wall in pic. I tried with processing 3sec job with 90/10  (Power/speed) setting. Please advice how to solve this problem.