Per my other post, I have been working on creating custom cut profiles with different power and speed settings. BUT, I can not set the nozzle and gas pressure I want to use. I tend to cut with 90PSI compressed air. When I select my custom cut profiles and start processing, I get an error about the pressure being too low. It would also be good if I can set my own focal distance recommendation.
Am I missing where I can set what nozzle, gas, and pressure are being used for a custom cut setting? If I am not missing something, can Xtool please adding access to these settings.
This applies both to the old XTool XCS as well as the new XTool Studio.
Thank you.
Copyright © 2025 xTool All Rights Reserved.