I am trying to CNC cut ¼ in carbon steel, however I can't find the correct settings in XCS, when I emailed Xtools support they said that it can't cut past 5mm.
However, the website says it can cut up to 10mm carbon steel…
I am very confused but have been tweaking the settings so much but still haven't found anything that has cut well, has anyone had any luck tuning XCS to cut ¼ in carbon steel?
My current cutting settings are:
Power and duty cycle: 100%
Speed: 15mm/s
Nozzle: Double layer nozzle
Gas: 12psi of pure O2.
Cutting frequency: 3000hz
perforating duration: 700ms
Perforation duty cycle: 60%
Perforation frequency: 1500hz
Any help would be very appreciated!! Thank you!
Copyright © 2025 xTool All Rights Reserved.