When you try to process a batch of materials at one time, the "Batch fill" function won't work or can not fully cover the canvas. A pop-up window shows up indicating, “Batch fill failed”, as shown below.

 

Clean the baseplate.

Use black tape or a black marker to cover obvious scratches.

 

Check if the material color is close to the black baseplate.

Spray a light-colored water-soluble paint on the surface of the material or replace the material with another color.

 

Clean the camera with a cotton swab moistened with alcohol.

 

Note: M1 only allows processing a batch of material of the same type and the same size each time.

Make sure that the materials in a batch are of the same size.

Process materials in different batches.

 

Note: Recognition on a honeycomb board is lower than that on the baseplate.

Remove the honeycomb board.

Try again on the baseplate.