xTool Store
The Laser Module Won't Home without Double-clicking "Home" on LightBurn
Updated Sep 21,2023
Updated Sep 21,2023
This article applies to:
D1 Pro with all laser modules.
Issue Description
When you connect the D1 pro extension kit to LightBurn, the Y-axis median line is on half of the Y-axis gantry.
If the laser module is above the median line, it will return to the top left corner after clicking "Home".
If not, it will return to the top left corner after double-clicking "Home".
This is because LightBurn is not compatible with the D1 Pro extension kit.
Solution
- Click "Console" and input the command "M205 X406 Y930 S1".
- Tap "Enter" to send the command.
- A message will be displayed on the "Console" interface, as shown below.
- Click "Home" on LightBurn again, and the laser module returns to the top left corner.
Note: You will not encounter this issue on XCS.
Preview
Was this page helpful?
0 out of 3 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket Tags
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket 
Services & Help
Learn & Education
Copyright © 2025 xTool All Rights Reserved.