XCS Finds Device Through USB But Shows as Unknown
Updated Dec 20,2023
Updated Dec 20,2023
Issue Description
When you use XCS to operate the machine, and it finds the device through USB but shows as unknown, please follow the instructions below to troubleshoot. This is usually because the firmware is not up-to-date.
Update the Firmware
Refer to the guide for upgrading the firmware of the machine to the latest version
If None of the Above Works
If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.
Preview
Was this page helpful?
1 out of 1 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Tags
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Call Us
Telephone Pre-sales : +1(970)638-7030
After-sales : +1(775)587-7760
Email Pre-sales : vicky@info.xtool.com
After-sales : support@info.xtool.com
Service Time Mon-Fri : 7:00 am - 5:30 pm (PT)
Sat-Sun : 8:30 am - 5:30 pm (PT)
Join xTool Squad
Copyright © 2024 xTool All Rights Reserved.