Troubleshoot Poor Smoke Extraction
Updated Aug 31,2026
Updated Aug 31,2026

Issue description

AP2 Max appears to be operating normally, but there is little or no airflow at the air inlet. Smoke extraction is poor, and smoke cannot be effectively removed.

Possible causes

  • One or more filters are clogged.
  • The cyclone is dirty.

Troubleshooting procedure

Step 1. Clean the cyclone

Clean the cyclone by following the steps in this video tutorial (starting at 04:37).

After cleaning, run AP2 Max again and check whether airflow and smoke extraction return to normal. If the problem persists, proceed with the next step.

Step 2. Check the filter life

Check the filter life status in the software. If a filter is found to be clogged and its filter life has expired, replace it with a new filter.

image.png

If the problem persists, proceed with the next step.

Step 3. Set the fan speed to 100%

Set the fan speed to 100%, then run the laser device and check whether smoke can be extracted properly. If the problem persists, proceed with the next step.

Step 4. Check the filters for blockage

Remove the filters one layer at a time and test AP2 Max after each removal to identify which filter may be restricting the airflow. Refer to the filter testing tutorial for detailed instructions.

If possible, record a video of the test for further troubleshooting.

If a filter is found to be clogged but its filter life is shown as normal in the software, please contact us for further assistance.

Still experiencing issues?

Should the issue persist after completing the preceding steps, submit a ticket via the "Submit a Ticket" button in the "Help Ticket" section below. The standard response time for xTool Customer Service is one business day.

For a prompt resolution, please include the following details:

  • Issue Description: A detailed explanation of the observed problem.
  • Video Evidence: Attach a video demonstrating the issue, where applicable.
  • Troubleshooting Performed: Any troubleshooting steps you have already attempted, along with their results.

This information is crucial for xTool technical support engineers to provide timely assistance.


Documentation feedback Help improve this content by providing feedback. If this content did not meet your requirements, select "No" in the "Was this page helpful?" section below. Include specific details about what was unclear or missing in the pop-up suggestion box. Feedback submissions are reviewed by xTool technical writers to enhance future documentation.
Preview
Was this page helpful?
0 out of 0 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
xTool Logo

Contact Us

🇺🇸+1 (833) 588-4887
Service Live Chat

Copyright © 2026 xTool All Rights Reserved.